No Products in the Cart
35% OFF - Enter the code: SPRING at checkout!
Free Standing Lace 3D Crown machine embroidery design
You have to embroider it on a water soluble material. (We worked on SOLVY 80 water soluble foil.) Be sure to embroider in the smallest hoop possible, minimum size of the hoop: 8×12". This is important, because it will ensure the embroidery stays tight.
When you have finished embroidering, remove the foil from the frame and tear off the embroidery.
Soak the embroidery you’ve made in water to dissolve the foil. Then squeeze out the water and let it dry. Finally, iron over the back side.
The crown consists of 2 pieces - so you’ll need to embroidery two times. The circumference of finished crown is 53 cm ( 20.8") .
This wearable 3D Freestanding Lace Crown now also available for 5 x 7" / 13 x 18 cm hoop!
The difference compared to the previous one is that 4 pieces of this size are needed instead of 2.
When you purchase the design, you will receive both sizes. If you have a bigger hoop later, it should be easier for you to create.
CSD, DST, EXP, EMA, HUS, JEF, SEW, SHV, PES, VIP, XXX
Width = 99.5 mm ( 3.91”)
Height = 288.4 mm ( 11.35”)
63657
1 : BRASS 1159 SU Rayon TEMPLE GOLD
Width = 145.4 mm ( 5.72”)
Height = 99.5 mm ( 3.91”)
32209
1 : DEEP GOLD 0000 GOLD GOLD
Width = 145.4 mm ( 5.72”)
Height = 99.5 mm ( 3.91”)
32208
1 : DEEP GOLD 0000 GOLD GOLD
